kadaitcha.cx

Consider the following scenario:

• You have a computer that is running Windows 7 or Windows Server 2008 R2.
• During the startup process of the computer, you insert a Secure Digital (SD) card. This SD card uses the PCI-Express (PCI-E) bus.
• After the computer finishes the startup process and the desktop appears, you remove the SD card.

In this scenario, the computer crashes and then you receive a stop error message on a blue screen. This stop error message resembles the following:

STOP: 0x000000D1 (parameter1, parameter2, parameter3, parameter4)
DRIVER_IRQL_NOT_LESS_OR_EQUAL

»«

Consider the following scenario:

• A computer is running Windows Server 2008 R2 or Windows 7.
• The IPSec tunnel is configured on a network by using IPv6 transition technologies, such as Intra-Site Automatic Tunnel Addressing Protocol (ISATAP) or IPv6 over IPv4 (6to4).
• The RequireinClearout mode is enabled on the IPSec tunnel.

Note This option is only valid on computers that are running Windows 7 or Windows Server 2008 R2.

In this scenario, the computer restarts unexpectedly and you receive the following error message:

STOP: 0x000000D1 (parameter1, parameter2, parameter3, parameter4)
DRIVER_IRQL_NOT_LESS_OR_EQUAL

When an outgoing clear text packet is sent by using the IPSec tunnel, an access violation occurs. This behaviour triggers the error message that is mentioned in the “Symptoms” section.

»«

Assume that you have a computer that is running Windows 7 or Windows Server 2008 R2. The Advanced Configuration and Power Interface (ACPI) BIOS on this computer contains a namespace object that is not a PCI device. However, Windows assumes that the device is a PCI device incorrectly. Therefore, if Windows tries to access the PCI configuration space for the device, you receive a “STOP 0x000000D1″” error message.

This issue occurs because of an error in the Acpi.sys system driver. The Acpi.sys system driver sets an incorrect value for the affected device. This causes the system to try to access the PCI configuration space for the device. However, the device is not a PCI device and the PCI configuration space does not exist.

»«

You attach a 1394 device to a computer that is running Windows 7 or Windows Server 2008 R2. In this scenario, the computer may crash after you resume the computer from sleep or from hibernation. Additionally, you may receive the following Stop error message:

STOP: 0x000000D1 (parameter1, parameter2, parameter3, parameter4)
DRIVER_IRQL_NOT_LESS_OR_EQUAL

»«